Welbilt Bread Machine Heavy Duty Pan Seal Kits for Model ABM1L2PS (7MKIT-HDX2)

Description: This new "Pan Seal Kits for the mini-loaf pans"Includes: Heavy Duty Seals, Stainless Steel Flat Washers, Stainless Steel Snap Rings, & Stainless Steel E-clips.will fit the model listed below: Welbilt Automatic Dough & Bread Maker Machine Model Number: ABM1L2PSTHANK YOU!Bread Machine Parts Finder***Important message about replacing the seal in the pan: The old red seal issued with the pan was manufacturedwith an outer diameter of 19mm. The 19mm outer diameter seal was cut down to 17mm by the manufacturer of the panto make it fit into the 17mm diameter hole of the pan. This action reduced the outer layer (mil) of the seal leaving itvulnerable to failure by weakening the seal's ability to maintain a sealed environment for the bearing assembly.Some of the seals will not stay in the pan's recessed hole. The seal will make it's way out during the mixing or kneadingphase. Even after firmly pressing the seal back into place it will still eventually work its way back out again. The second problem with the cut down seal is that it may be cut crooked when reducing the diameter. This will result in failure to maintaina sealed environment as well as becoming stuck within the pan's recessed hole. This creates a third problem. When a sealis stuck within the pan's recessed hole it makes it very difficult to remove. At least 50% of seals cut crooked that are stuckin the pan's recessed hole will not come out without damaging the pan's recessed hole. If the hole is damaged whileremoving the seal from the pan it cannot be repaired. The pan will never seal again. ***If the seal is making its way outon its own during the mixing or kneading phase, then you will be able to easily install a new seal. ***If you have to removethe old seal by tapping the drive shaft through to push it out and the seal easily pushes through with minimal forceapplied, then you will be able to easily install a new seal.***If the seal is very difficult to remove or will not budge unlessexcessive force is applied, then you will most likely damage the pan's recessed hole making the non-repairable. ***I strongly recommend removing the old seal before purchasing a new seal so that you can determine if the pan is in factrepairable.***My new seals are manufactured with an outer diameter of 17mm. Never cut down or reduced to fit! Thissolves the problem with the old red seal!

Price: 27.99 USD

Location: Altoona, Florida

End Time: 2024-12-30T03:40:15.000Z

Shipping Cost: 11 USD