PinOne Virtual Pinball Board

Description: The PinOne board is a new offering to the pinball community! It is an open source project that is fully supported by the Arduino platform and is compiled and built on the atmega32u microchip. It also has a number of new offerings that are not currently available in Pinscape. For a full list of features, see below: Core Hardware FeaturesFully DOF and DOFLinx compatible board31 outputs built into the board (20 PWM and 11 on/off outputs)16 5v onboard PWM outputs are capable of providing low current outputs for LEDs and have current limiting resistors built in. No need for an additional power supply to run LED buttons as they are all powered by the USB powerUsing expansion boards can provide an additional 32 outputs for a total of 63 outputs24 inputs for buttons and other devicesSeparate input for potentiometer based plungerHigh accuracy accelerometer and gyroscope for excellent nudge supportSuper low latency "0 delay" button encoderSoftware Enabled FeaturesFull graphical utility tool for customizing and configuring the board for your systemUp to 4 inputs can be assigned to activate any output, allowing for a lot of cool possibilities, but the main use case is to allow the flipper buttons to activate solenoids, so you can have full feedback without configuring any software at allThere is a full "Light Show" embedded on the board, so even if you don't have DOF configured, you can still enjoy lights flashing and changing colors during game play.All outputs can have timed outputs enabled for auto shut off to protect your equipmentAll PWM outputs can have a timed "low output" state that ensures after a period of time that the outputs are turned down to a lower levelAll PWM outputs can have a configured maximum output level so you don't have to rely on external software to change the level of outputsOutputs can be configured for "Night Mode", allowing certain outputs to turn off when the night mode switch is activatedAccelerometer has a dead zone tuning utility that allows you to capture the ideal dead zone to ignore while toys are activated to ensure there is never any nudge event set off by the toys in your cabinetAccelerometer can be configured to activate a button press when it reaches a certain level, effectively simulating a tilt bob via softwarePlunger can be configured to activate a button press when pushed in a certain level and also when extended to a certain level, allowing the plunger to be used normally to activate the fire button

Price: 45 USD

Location: Willoughby, Ohio

End Time: 2024-09-15T19:48:56.000Z

Shipping Cost: 8.9 USD