Magnetic Shielding G-Iron Superflex

Description: REVISED: ONE LAST PIECE LEFT. APPROX 10.5” LONG 25.5 WIDE Magnetic Shielding G-Iron Superflex. Magnetic shielding high quality and performance. Flexible, nickel free 1mm thick. Over all thickness about 1/8” Maybe the best price of this material you can find. Product was only used laid down on an apartment bedroom floor carpet and cut into 3 sections. 2 longs about 10’ and 1 short about 5’ …. Some of the sharp edges are tapped with duct tape for safety. Cost over 1200.00 shipped at the time about 2 years ago. Saved me in a pickle. The situation was the apartment unit was a floor level carpet over concrete newer construction build with all metered power wires buried below concrete in line with the circuit breaker boxes. So many of the units wires were buried under my unit being closer to one side of the building where the power gets fed in. The unit was blasted with EMF field unusually high compared to the other 2 connected buildings. In the center of the unit where the wires/cables were buried I was seeing milligauss readings from 15 to 30 or more and over 1 being the safe limit. Readings were highest in the summertime when everyone was using their AC units. The whole unit had over 1.5 to 2.0 milligauss readings minimum. This material helped greatly by reducing the anntinuation or radiation by half or more lowering the overall magnetic radiation in the sleeping area. I since moved out. No longer need this. For those of you that don’t know this material is designed for magnetic radiation, EMF, which is harder to block and requires special material unlike what’s used for electrical, ELF, and radio frequency, RF. Hence the cost, it was purchased from lessemf.com. more information can be found on the site searching the product name G iron super flex. I will post more information as of now they are sold out and back ordered on the material. G-iron, per foot. 25.5 inch wide, 1 mm thick. Weighs 3.5 Kg/m² (about 15 pounds per 10 foot length). Edges are sharp. Description GIRON Magnetic Shielding Metal Film, which does not contain Nickel, is unlike any other magnetic shielding material available on the market today. Suitable for high field strength applications requiring high saturation and good permeability, it is both thin and strong, and unlike Mu-metal™ it is very tolerant to bending or shaping without losing its shielding properties. GIRON is a woven, laminated material. Cuts neatly with snips or sheet metal tools, and can be used either flat or molded into shapes for best performance. Suitable for small shields on magnets, motors, speakers and appliances such as refrigerators, vacuum cleaners etc. Also great for lining car floor or firewall. Perfect for full or partial wall / floor shielding in rooms too! Can be glued, taped, nailed, screwed or riveted into place. Could even be used to make a (heavy weight) vest to shield a person’s torso! Works with AC or DC magnetic fields (0-1000 Hz), and will tolerate temperatures from 32° to 140°F. Laminated with a 0.005 inch glass reinforced polypropylene tape which is UV sensitive, cover if installation is exposed to direct sunlight. Initial permeability: 500 Relative permeability: 7000 Saturation induction: 2,0 T Curie Temp.: 740°C (1364°F) Weight is approx 1 lb per square foot Thickness: 0.9 mm (0.034 inch) 25.5 inch wide, 1 mm thick. Weighs 3.5 Kg/m² (about 15 pounds per 10 foot length). Edges are s

Price: 35 USD

Location: Saint Cloud, Minnesota

End Time: 2024-12-08T07:24:21.000Z

Shipping Cost: 0 USD