Jeep Wrangler 2000-06 (TJ/LJ) Cabin Filter Adapter with filter and splash guard

Description: Install a cabin filter in your late model Jeep Wrangler TJ! These vehicles never included one from the factory and instead just blow exterior air directly into the cabin. If you have ever been on a dusty road in your Jeep, you know how bad this is. Not only does it get your interior dirty and make you breathe the dust, but it can clog up your heater core. This adapter allows you to install a proper cabin filter over the under-cowl interior air intake to reduce dust, pollen and other contaminants from making it into your cabin. This version of the filter adapter includes an additional shroud that serves as a splash guard. This is not really necessary but some people prefer to have a little more cover over the paper filter element in case water makes it under the cowl. Normally this should not be necessary because the flange around the air inlet is designed to let moisture run down to the center cowl drain. However, if you have a damaged or modified cowl cover, you may prefer this version with extra protection. The cover fits over the regular filter adapter itself and is held in place by the same screws. The filter adapter included here is the same as my other listings - the cover just sits on top. Installation is easy and requires only a screwdriver to remove the cowl and install the adapter. After that, replacing the filter is as easy as lifting out the old one and putting in a new one. A filter and longer screws are included so this package is ready to install when it arrives. This takes a standard cabin filter which is used on later Jeep Wrangler models, Jeep/Mopar part number 55111302AA. The Fram FDC11777 will fit, but any other brand for a 2011-2013 Jeep Wrangler will work as well. Replacement filters can be had for about $5 each. There are three versions of this adapter available, depending on what you want: - Filter adapter with a filter: Item 115913873730 - Filter adapter only (you supply your own filter): Item 115971760424 - Filter adapter with a filter and a splash guard: (this listing) Sometimes this item is out of stock because I am out of filters, so you can order just the adapter above and source the filter locally. Notes: This is intended to fit 2000-2006 Wrangler/TJ/LJ models. (NOTE that 2000-2001 have been reported to fit just fine, but the service manual shows additional ducting that may need to be cut/trimmed. I have seen 2000s with and without this ducting, so if you're worried about cutting it, look under your cowl before you order. Contact me with pictures of your duct if you want to confirm before ordering!). Be sure to confirm that your Jeep has an intake under the front cowl like the one pictured before ordering. Message me for details first if you need help! You should be able to re-use the factory screws from the intake boot, but due to differences in Jeep manufacturing tolerances, you may need longer hardware (not included)This is a retrofit and as such it does not form a perfect seal and will not prevent all dust and contaminants from reaching the cabinThis is a 3D-printed part using ASA (ABS). Color and finish may vary. Heat tolerance of 200F is typical.I usually ship the same or next day, but as these are made to order sometimes it may take longer due to high demand and material availability. You can be sure that I'll be working hard to get your item in the mail as soon as possible. Design is PATENT PENDING.

Price: 49.95 USD

Location: Happy Valley, Oregon

End Time: 2024-09-25T15:08:24.000Z

Shipping Cost: N/A USD