iFlight Blitz F7 Pro Flight Controller V1.1

Description: iFlight's Blitz line of electronics features improved circuit designs, better components, and lower electrical noise. This results in better performance, durability, and reliability. These are fantastic parts for any build. The Blitz F7 Pro Flight Controller is a fully encased board with connectors for every output and UART. It comes with a wiring harness for every single port. No need to solder anything. Plug-n-play is here! Features: Improved circuit design, better components, and lower electrical noise! DJI HD VTX Connector (Plug-and-Play / No soldering required) FC indicator LEDs for visual debugging 512MB BlackBox With LC filter Specifications: Mount pattern: 35*35mm/ 4mm PCB hole diameter Smartaudio / IRC Tramp VTX protocol supported Firmware target: IFLIGHT_BLITZ_F7_PRO Input Voltage: 14.8V-34V (4S-8S LIPO) Motor outputs: 4x (SH1.25 connector) Flash: 512MB (Blackbox flash) I2C serial: SDA / SLA pads Dimensions: 41*41.5mm Barometer: DPS310 OSD Chip: AT7456E LED controller: Yes MCU: STM32 F722 Weight: 17g (±2) Beeper pad: Yes Gyro: MPU6000 UARTS: 4 Wiring Suggestions: UART1 for VTX HD/Analog UART2 for Receiver UART4 for GPS UART5 for ESC Telemetry 8×Dshot/PWM outputs 1×I2C for GPS Mag Tips: F722 MCU has an inner inverter. SBUS、CRSF、ELRS、IBUS、DSM ETC... can be connected to any unused UART_RX, we suggest you connect to Uart_RX2 Frsky SmartPort, Tramp & Smartaudio can be connected to any unused UART_TX, we suggest you connect to Uart_TX1 F.port can be connected to any unused UART_TX, we suggest you connect to Uart_TX2 Includes: 1x iFlight Blitz F7 Pro Flight Controller V1.1 Wiring Harness For every port Download Wiring Diagram

Price: 99.99 USD

Location: Madison, Alabama

End Time: 2024-12-12T22:22:04.000Z

Shipping Cost: N/A USD