Assembled 2Stroke Bicycle Engine Kit YD100 40mm*50mm Gas Motor Kit 79/80/100CC

Description: Assembled 2Stroke Bicycle Engine Kit YD100 40mm*50mm Gas Motor Kit 79/80/100CC. Gasoline motor: YD100-CDH100CC(Real Displacement is 79cc/80CC) Engine Type: Single cylinder, air-cooled,2-stroke Mixing Ratio of Fuel(90#) and Engine Oil: 16: 1 for New sets, 20: 1 after Running 500Km Power: 2.0KW Bore and Stroke: 50mm x 40mm Cylinder inner diameter: 50mm Piston outside diameter: 50mm Maximum speed:45-50km/h 8mm front and rear mount studs NEW Red CDI IGNITION Cylinder Head and Cylinder Two In One, better design for cooling, higher power with hill driving easily. YD100-CDH100CC Differences with Standard 80cc engine kits: Two in one cylinder, Crank, Piston kits, CDI, Carburetor, CDHpower 2 Stroke Gas Bicycle Engine kit YD100-CDH50mm 79CC/80CC Engine Kit; Bore and Stroke: 50mm x 40mm; no CDH sticker on motor; Better adjusting clutch a little before riding Cylinder head and Cylinder two in one piece; 50mm bore;Higher performance red speed carburetor and Higher performance CDI with Yamaha components; Improved magneto as well Cylinder inner diameter 50mm; Piston outside diameter 50mm; 8mm front and rear mount studs; 40mm alum intake stud spacing,NEW Red CDI and 36T Sprocket,but Manual is INCLUDED Clear up the cylinder transfer ports before assembling maybe some rough slag inside which maybe break off and cause the jamming of pistons and cylinders;fully attention on screwing cylinder to the end bottom,DO NOT screw M8 bolts tightly that maybe cause drill through the end bottom so add some gasket or washer on head is better way to prevent it happen; Attention on piston ring if put the piston out of cylinder, the piston rings are weak, better with right way install piston kit to cylinder CDHpower 2 Stroke Gas Bicycle Engine kit YD100-CDH 79CC/80CC Engine Kit; Bore and Stroke: 50mm x 40mm Cylinder head and Cylinder Two in one; Engine Type: Single cylinder, air-cooled,2-stroke NEW Red CDI Cylinder inner diameter 50mm; Piston outside diameter 50mm; 8mm front and rear mount studs; 40mm alum intake stud spacing,NEW Red CDI and 36T Sprocket,but Manual is INCLUDED Clear up the cylinder transfer ports before assembling maybe some rough slag inside which maybe break off and cause the jamming of pistons and cylinders; fully attention on screwing cylinder to the end bottom,DO NOT screw M8 bolts tightly that maybe cause drill through the end bottom so add some gasket or washer on head is better way to prevent it happen; Attention on piston ring if put the piston out of cylinder, the piston rings are weak, better with right way install piston kit to cylinder

Price: 129.99 USD

Location: Tucson, Arizona

End Time: 2024-08-24T15:10:14.000Z

Shipping Cost: 19.99 USD