AL-310S X-Axis Y-AxisTorque Power Feed for Table Milling Machine 0-200RPM 220V

Description: AL-310S X-Axis Power Feed Kit is for Bridgeport and Similar Knee Type Milling Machines. These will fit almost any vertical knee type mill out there with the 5/8" Shaft End, Including but not limited to Bridgeport, Precision Matthews, Grizzly, Enco, Jet, Sharp, Acer, Webb, GMC, Kent, Clark, Supermax, Enco, Turn Pro, Vectrax, Acra, Birmingham, Accu, First...etc. The gear ratio between transmission plastic gear and motor shaft gear is not a whole number. The two gears will not mesh and wear at the same spot, this not only increases durability and longevity but even reduces noise over time. Feature： Type: X traverse Model: Al-310S Voltage: 220V,50Hz Rotate speed: 0-200 RPM Max torque: 450 in-lb Max feed rate: 650mm/min Max return speed: 850mm/min Effortless operation Noiseless direction changes Better surface smoothness Small volume and easy installation Excellent speed control in the entire range Power table feed won't vibrate or strain in low speed Direction control knob for easy and rapid operation Safety feature to protect transmission gear and electronic components Warning： 1. To stop jog operating, you must first turn “FEED KNOB” to “0”(OFF) position. Then move “JOG SWITCH” to “FEED” position. 2. Be sure to follow the procedure for jog operation to avoid any damage caused by wrong movement. Package Content： 1 x Power Feed For Milling Machine 8 x Adjustable Pad 2 x Tiavel Stop Assembly 1 x Adapter 1 x Bevel Gear 1 x Dial Nut 1 x Locking Nut

Price: 370.91 USD

Location: shenzhen

End Time: 2024-12-30T03:26:35.000Z

Shipping Cost: 0 USD