4 Guides From Frankenslot for Slotit Slotcar Vehicles New

Description: 4 guide keels from Frankenslot with mounting screwsThis guide keel has an optimized geometry on the guide keel sword and is especially for the Carrera track. Not suitable for Ninco rails.The centerboard is deeper and wider than the Slotit keel, so the points are switched cleanly (in digital operation) and the guidance in the curves is improvedMaterial Polyamide with glass fiber, weight 0.70 gramsSword depth 6.9 mm, shaft diameter 3.60 mm, total length approx. 22.5mmNote: this guide keel is for the new chassis generation from Slotit!Screw in grub screws M2 x 3 to secure the cable to fasten the wiper wire.old chassis have a mounting height of 4.8 mm (e.g. 956 Porsche). The new CS03T60B chassis for all P956/962 has a height of 5.1 mm at the mount, and the bore is smaller at 3.70 mm.For a correct fit / guidance of the guide keel, you have to file off this 0.3 mm with a file so that an ideal play can be set with the screw.In addition, we have found in tests that there is a burr at the top of the mount in other chassis types where guide keels with a clip function are installed (e.g. GT 40). This burr must be removed for the guide keel to rotate cleanly.Other chassis have a burr in the mounting hole at the bottom. If the guide keel can only be moved slightly from above, the ridge is below. This edge must therefore be broken off briefly from the assembly side with a scalpel or cutter.With new chassis from 2015 no adjustment is required! 100% Made in Germany and wear-resistant. Not suitable for children under 3 years.The centerboard is deeper and wider than the Slotit keel, so the points are switched cleanly (in digital operation) and the guidance in the curves is improved old chassis have a mounting height of 4.8 mm (e.g. 956 Porsche). The new CS03T60B chassis for all P956/962 has a height of 5.1 mm at the mount, and the bore is smaller at 3.70 mm. In addition, we have found in tests that there is a burr at the top of the mount in other chassis types where guide keels with a clip function are installed (e.g. GT 40). This burr must be removed for the guide keel to rotate cleanly. Other chassis have a burr in the mounting hole at the bottom. If the guide keel can only be moved slightly from above, the ridge is below. This edge must therefore be broken off briefly from the assembly side with a scalpel or

Price: 15.62 CAD

Location: Nürnberg

End Time: 2024-01-24T00:09:36.000Z

Shipping Cost: 6.51 CAD