2 KEYSTONE RV TRAILER "MONTANA" LOGO DECALS GRAPHIC

Description: DESCRIPTION You are purchasing two Keystone RV trailer "Montana" graphic decals - #661, exactly as pictured. These were made for Keystone's Montana RVs and manufactured by Arlon in Santa Ana, CA. See their UPC label in the pics. These are for the sides of the camper. I also sell the exact same ones for the front that are bigger. See my other listing on the big ones, item# 226055483331. (Just type that number in the eBay search bar). You won't find 2 of these decals at this price in the entire country. FEATURES 1- RV/Auto/Boat GraphicThis sale includes a single decal.Measurements: 59" inches across in length x 9.6" inches in height with a largest letter "M", the thickest point of the decal.Colors depicted: Grey/Black with cream colored border.Decals can be applied to any flat non-porous surface.Decals are made from 3 mil Premium Outdoor vinyl and UV lamination to last at least 7-8 years. APPLICATIONSteps one and two: Unroll and BurnishLay your Montana Vinyl Decal on a smooth, hard surface such as a tabletop, wall, or floor. Use a squeegee or a credit card to burnish the transfer tape to the vinyl graphic by rubbing over it with a very hard pressure. Now, flip it over and repeat on the back side. This will adhere the Transfer Tape to the Vinyl Decal well so that the backing paper will remove more easily. Steps three and four: Position and Secure for the Top Hinge MethodEyeball where you want to place your vinyl Decal, or use a measuring tape to determine the correct position. Use painter's tape to tack the vinyl decal in place on the top corners. If required, use a bubble level to check that the design is level by placing it on the 1/8" trim line that surrounds your decal. Adjust as necessary. once you have your Vinyl Decal installed on your surface you will not be able to move it to another position, so take the time to double check that your design is level and EXACTLY where you want it to stay! Run a strip of Painter's tape across the top of the design, with half of the tape on the wall and half of the tape on the front of the decal. This is your "tape hinge". This Top Hinge Method works well for smaller vinyl decals (under 2") that can be applied by one person. Step five and six: Flip, Remove, and RollFlip the decal up (like opening a door) and carefully peel the Backing Paper off from the hinged edge. Pull the Backing Paper back slowly at a 180-degree angle, using the flat of your hand to push the vinyl down onto the Transfer Tape as you slide the Backing Paper off. Avoid touching the adhesive on the Vinyl Decal if you can. If the decal wants to come with the Backing Paper, simply roll backward a bit and push the decal back down onto the Transfer Tape using the flat edge of your fingers while you pull back. Once the Backing Paper is removed, slowly roll the Vinyl Decal down on the surface from the hinged edge. Use the Squeegee or the palm of your hand to smooth and secure the decal from the center outward. Step Seven and Eight: Burnish and PeelUse the squeegee to burnish the Vinyl Decal securely to the wall or surface with the Transfer Tape still in place. Slowly peel back the Transfer Tape form the top down, again at a 180-degree angle, taking care that the Vinyl Decal stays securely on the wall.

Price: 19.99 USD

Location: Theodore, Alabama

End Time: 2024-12-18T22:13:12.000Z

Shipping Cost: 0 USD