13 Screwdriver Holder For Ryobi Link Rails, pegboard, or wall. Garage Tool Black

Description: 13-piece Screwdriver Holder for Wall, Pegboard, or Ryobi Link Wall Rails This Screwdriver Holder holds 13 screwdrivers. There are funnel-shaped slots for 6 medium/typical-sized screwdrivers, 6 precision/small-sized screwdrivers, and 1 large multi-bit screwdriver. It works with a wide variety of screwdrivers but also works well with Ryobi screwdrivers. Shafts of the funnels are round but the tops transition to square-ish shapes to fit most screwdriver heads. See photos. The back is designed to mounted in a variety of ways including screws to the wall, pegboard* with holes at 1" on center, and Ryobi Link Wall Rails. If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw to hold it into place. No Screwdrivers nor screws are included. Screwdrivers shown in photos are for reference purposes only. * Note that there are many different types of pegboard and some may not work. This was designed to work on 3/16" thick masonite pegboard with holes at 1" (25.4mm) on center only. It is 3D-printed in black PLA plastic. It is 9" x 2.9" x 3.5" (230mm x 74mm x 90mm). PLA plastic which is made from a renewable resource. It’s biodegradable and eco-friendly. These are lightweight and due to the printing process, there may be some imperfections. 3D Printing involves the heating and depositing of material on a flat board one layer at a time. Each is custom printed in the USA to order.

Price: 19.95 USD

Location: Lexington, Kentucky

End Time: 2024-07-19T01:23:51.000Z

Shipping Cost: 0 USD